ANTENNA
DESCRIPTION
All models use a fixed-length stainless steel rodtype
antenna mast, installed on the right front
fender of the vehicle. The antenna mast has a spiral
groove cut down its length to reduce wind noise. The
antenna mast is connected to the center wire of the
coaxial antenna cable, and is not grounded to any
part of the vehicle. To eliminate static, the antenna
base must have a good ground. The coaxial antenna
cable shield (the outer wire mesh of the cable) is
grounded to the antenna base and the radio receiver
chassis.
The antenna coaxial cable has an additional disconnect,
located near the passenger side cowl side
inner panel behind the lower instrument panel reinforcement.
This additional disconnect allows the
instrument panel assembly to be removed and
installed without removing the radio receiver.
The factory-installed Electronically Tuned Radios
(ETR) automatically compensate for radio antenna
trim. Therefore, no antenna trimmer adjustment is
required or possible when replacing the radio
receiver or the antenna.
Еди Рангелов : 0885 088 444
Няма незаменими има незабравими хора !!!
Еди , да те питам в тази тема да не отварям нова за един въпрос.
Сигнала за управление на бутоните на радиото от волана, аналогов сигнал или цифров изпращат към радиото.
Здравей , опитай с този ( 1431 ) , но не съм сигурен , на тази партида Т 00 АМ .......... май не може да се генерира код с моята програма , опитай ако не става ще трябва да ходиш до Б.Стар
Еди Рангелов : 0885 088 444
Няма незаменими има незабравими хора !!!
Здравей , опитай с този ( 1431 ) , но не съм сигурен , на тази партида Т 00 АМ .......... май не може да се генерира код с моята програма , опитай ако не става ще трябва да ходиш до Б.Стар
Коментар